Suitable for easy to ravel and knit fabrics, as Straight stretch stitch well as joining durable fabric such as denims. These stitches can also be used as decorative top stitches.Reverse button Hold down this button to sew either backwards or a reinforcement stitch at a low speed.
Auto-lock button Hold down this button to sew locking stitches immediately or at the end of the current pattern and automatically stop. Before connecting the power supply, make sure that the voltage and frequency shown on the machine is conforming with your electrical power. Foot control With the sewing machine turned off, insert the foot control plug into its connector on the sewing machine. However, if you choose to adjust the presser foot pressure, turn the presser adjusting screw with a coin. For sewing very heavy fabric, loosen the pressure by turning the screw counter clockwise, and for thin fabric, tighten by. Standard foot (T) Satin stitch foot (A) Inserting zippers Zipper foot (I) Buttonhole sewing Quilting Quilting foot (P) Buttonhole foot (D) Free-motion, Darning, Embroidery. For smaller spools of thread, place spool cap with the small side next to the spool or use the small spool cap. Snap the thread into the thread guide. It will disappear from the LCD screen when the bobbin winder spindle is push to the left, sewing position. When inserting or removing the bobbin, the needle must be fully raised. Remove the bobbin cover and insert the bobbin in the bobbin case with the thread running in a counterclockwise direction (arrow). ![]() Lower the needle threader lever slowly and draw the thread through the thread guide as illustrated and then to the right. To reduce the tension, turn the dial to the next number down. There is no single tension setting appropriate for all the stitch functions and fabrics. Turn the handwheel toward you (counterclockwise) lowering, then raising the needle. Gently pull on the upper thread to bring the bobbin thread up through the needle plate hole. The presser foot lift raises and lowers your presser foot. When sewing several layers or thick fabrics, the presser foot can be raised higher for easy positioning of the fabric under the foot. RAISE OR LOWER THE FEED DOGS With the accessory box off the machine, the feed dog adjustment lever can be seen on the base in back of the sewing. When the patterns 06-16, 30-60 (C10), 06-16, 30- 79 (C20) are selected, press the Auto-lock button, the machine will sew 3 locking stitches at the end of the current pattern and automatically stop. The stitch width can be changed by pressing the stitch width buttons. The stitch length can be adjusted by pressing the stitch length adjustment buttons. The LCD will display the mirroring function and the machine will continue to sew the mirrored pattern until the mirroring function is pressed again to cancel. Press the button again to leave the memory mode and return to Direct mode. Stop the sewing machine when you reach a corner. Lower the needle into the fabric with the hand wheel or by pressing the needle up down button once. Raise the presser foot. Use the needle as a pivot and turn the fabric. This ensures even feeding at the beginning of a seam and helps when sewing multiple layers of fabric such as sewing over. ![]() When you press the - stitch width adjustment button, the needle position will move to the left. When you press the stitch width adjustment button, the needle position will move to the right. Suitable for easy to ravel and knit fabrics, as Straight stretch stitch well as joining durable fabric such as denims. These stitches can also be used as decorative top stitches.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |